SE Screw Type Pelleter

Working principle: SE series of screw type extruding pelleter include single-screw type and double-screw-type. Two models of front and side for material to be extruded out. Wet material or material with low melting point (general means < 50?) after being kneaded and mixed shall be extruded out from mould plate at the head of the plant due to being conveyed and pressed by screws, and then be dried or cooled to form end products of particles so as to complete the course of changing material from powder to particle. The shape of grain is cylindrical. The diameter of end grain can be chosen and controlled by means of changing the diameter of holes in the mould plate: for side type is 0.7-2.0mm,for front type is 1.5-12mm. The rate of end product is equal to or more than 95%.

SE Screw Type Pelleter